When our customers need to purchase electric heating tubes, they will compare the suppliers and hope to buy the most cost-effective electric heating tubes.
After the preliminary inquiry, communication, sample comparison and the final determination of the supplier, how to judge whether the electric heating tube provided by the supplier is of high quality?
Generally there are the following standards;
Is the design reasonable?
This includes the selection of the power of the heating tube and the quality of the outer tube.
The power design of electric heating is a comprehensive consideration of various factors, mainly based on the surface load of electric heating tube to calculate, and liquid heating and dry air heating tube on the surface load requirements are also different.
In general,
In the case of water scale is not serious, the surface load of the electric heating tube is controlled below 10W/ C ㎡;
Air dry heating tube surface load control in 8W/ C square meters.
Of course, the final power design needs to be designed according to the specific situation. The above is a very conservative design, which requires accurate calculation. Welcome to contact us directly.
For the outer tube material selection of electric heating tube,
SUS 304 is used for non-acid and non-alkaline liquid heating or dry air heating at operating temperature below 300℃.
SUS 316L is used for weak acid and alkaline liquid.
SUS 316L+ coating for strong acid and strong base;
SUS 321 is used for air dry firing at operating temperature between 300℃ and 500℃.
SUS 310S is used for gas dry firing at temperatures between 500℃ and 800℃.
IQC phase inspection
Upon receipt of the electric heating tube, the quality control department shall inspect its electrical properties, including,
The outer tube inspection: the outer surface is intact, bright, the welding is firm, the welding joint is beautiful, the bend shape is well formed, symmetrical, the sealing silicone is uniform, and there is no glue impurities in the screw teeth.
Power, resistance is within the tolerance range, power (+5%, -10%), resistance value (+10%, -5%);
Insulation resistance shall be > 1000 m Ω;
Leakage current ≤0.5mA;
Water pressure test (under the pressure of 1.2MPa, the welding place of the heating pipe shall not have water leakage and water seepage, and the pressure holding time shall be 5 minutes)
The service life






























