The hot part of the cartridge heater penetrates into the heating material, and the heating value of the heating element shall not slowly exceed the allowable heating temperature to avoid damage. In addition, a portion of the lead wire should be exposed to the insulation layer of the electric heater or the outside of the electric heater to avoid excessive temperature and harm.
After entering the switching power supply, do not exceed 10% of the rated current shown on the heating cartridge. If less than the rated current is applied, the heat produced by the individual heating tubes will also be reduced.
Tighten the terminals of the heater with two nuts to avoid damage to the heating pipe caused by loosening the screws forced out.
The wiring end of the heating cartridge is clean, dry and impatient, but reduces the dielectric strength energy, and is connected due to short circuit fault. In the use of chemical corrosion, flammability, flammability explosion and other natural environment with liquid or steam, part of the heating pipe wiring with insulating layer sealed equipment can be safe protection, prevent safety accidents.
When heating some chemical substances (such as sodium nitrate, paraffin, etc.), heating should reduce the power supply voltage, in order to reduce the heating value of the heater cartridge, in all melted into liquid, and then rise to the rated heating current.
Cartridge heater should be stored in dry storage. If the surface is wet as long-term placement, use a megohmmeter to accurately measure the grounding resistance in the application. If less than 1 megohm /500 VOLTS, the heating element should be placed in a drying box of 200 degrees for air drying.
Thick pipe scale and oil stains are accumulated on the surface of the cartridge heater after long time using,it should be removed at anytime. Otherwise, the heat conduction characteristics of the heater element will be reduced, and the heat consumption of the tube surface will exceed the rated damage.






























