
High density cartridge heatering elements excel in performance and durability. Using value-added controls, specialized coatings and finishes, and optimized design.
High Density Cartridge Heater in two basic forms - high density and low density. High density cartridge heaters are used to heat plastic injection moulds, dies, platens and so forth, whereas low density cartridge heaters are more suitable for packing machinery, heat sealing, labelling machines and hot stamping applications.
- More options for higher performance heaters
- Internal thermostats, thermal fuses, thermocouples and temperature sensors
- Non-Stick Coating
- Controlled Heat Profile
- Electropolish and passivation
Design Options
- Sheath: 304 stainless steel, 316L stainless steel, Incoloy
- Lead Exit: straight, right angle, elbow, double ended, bent radius
- Lead Wire: fiberglass, silicone, Teflon, Teflon® high amperage, straight pins
- Outer Jacket: stainless steel braid, stainless steel cable, strain relief spring, silicone, fiberglass, steatite ceramic beads
- End Seal: mica, ceramic, silicone, Teflon, epoxy
- Fittings: silicone rubber overmold, post terminal, UL listed plug, bolt heater, conduit box
- Mountings: threaded fittings, locating ring, flange
- Lead: crimped on, swaged in, no-heat extension
- Special Coatings: non-stick, electropolish, passivation






























