Description

Instant water heater element is a heating element that is immersed in the liquid (as in a hot-water tank) heating element - the component of a heater or range that transforms fuel or electricity into heat.It is made of magnesium powder and high quality stainless steel material, durable and long service life.

Instant water heater coil heater can be found inside a hot water cylinder.It works a little bit like a kettle, in that it uses an electric resistance heater to heat the water around it. It is the ideal heating element to install in small size immersion water Heater.

Compared with the storage type water heater, instant water heater's size can meet the requirements of fast heating, and it is very popular with consumers in the past two years.So how is the instant electric water heater heated?Concerning the storage type water heater,the heating element is placed in the inner tank to heat the local or the whole container, the instant hot water heater also has the inner tank, but the inner tank is the heating cup, the heating element is placed in the heating cup, the two ends of the heating cup and the water pipe are connected, the water flow through the high-power heating tube at a certain flow rate to heat, to achieve the purpose of heat.

Stainless steel heating element has the advantages of low production cost, strong corrosion resistance, dry burning resistance, high strength, dense surface, mature process, etc., the disadvantage is that there is no good thermal conductivity of copper heating tube; Although copper has good thermal conductivity, no welding, no gap, it is less prone to scaling than stainless steel, but its price is much higher than stainless steel, the production cost is large, and the quality is soft, and the corrosion resistance is poor. Therefore, most of the instant hot water heaters on the market are made of stainless steel heating element.

Advantages

1.This is the most astonishing aspect of the instant heating system for me! Previously, I used a storage water type. In the morning when I was in a hurry to wash up, I had to let the cold water run for one minute before it heated up. Now I've switched to the instant heating type. After turning on the tap, warm water comes out in about 3 seconds.

2.The previous storage-type water heater hung on the wall like a large box, taking up half of the wall space and leaving no room even for the bathroom cabinet. After switching to the instant heating type, the space was completely liberated - it is only 30cm×20cm×10cm in size, even smaller than a shoebox.

3.The most annoying thing about storage water heaters is the "power consumption during off-peak hours" - even when not in use, they still have to keep heating to maintain water temperature. I used to check the electricity bill and found that the water heater alone cost over 80 yuan per month. The instant heating type is different. It is only powered on when hot water is used, and it consumes energy only when cold water flows through the heating tube, with no heat preservation loss at all

Data Sheet

Sheath	Stainless Steel 304,310,316,Incoloy 800,840/(Optional)
Resistance Heating Wire	NiCr,FeCr (Optional)
Insulation Material	High-purity MgO
Certification	CE,ROHS
Rated Voltage	12-400V
Rated Power	50-10000W
Working Frequency	50-60Hz
Continuous Operating Temperature	≤750℃
Maximum Working Temperature	Max 800℃
Design Lifetime	10000+ h
Insulation Resistance (cold)	≥500MΩ
Maximum Leakage Current (cold)	≤0.5mA
Internal Thermocouple	Type J or K available
Thermocouple Location	Disc End, Sheath, Center of Heater