Threaded cartridge heating element

Threaded cartridge heating element

​Electric heater cartridge is made of MgO powder and MgO tube, ceramic cap, resistance wire (NiCr2080).
Send Inquiry
Description

Description

 

Cartridge heating element with thread is mainly used for efficiently heating tools and workpieces. To this effect, the heating cartridges are pushed into a hole in the tool and fixed there. Different diameters and designs make sure that the temperature distribution matches the specifications as well as possible.

Installation diagram or points need attention of cartridge heater

We have placed the resistance wire as close to the outside shell as possible. The MgO powder insulation around the loops is compacted by swaging, which makes the heat transmission very efficient. Our high-density cartridge heaters can have up to 200 w/in2 watt densities.

Threaded cartridge heating element is made by the procosee that welding  thread on the basis of cartridge heater, thread can be metric thread, pipe thread and so on. They are generally used to heat liquids, such as water, oil, corrosive liquids, etc.

The material of the threaded cartridge heating element can be as follows:

If heating the water for use,recommend ss304,ss321.

If heating the drinking water,recommend ss316L.

If the water is bad condition:recommend ss316L and ss310s,incoloy800.

The threaded cartridge heating element is mainly applied in:Small water tanks, oil tanks, experimental small containers, small water basins, etc. It is customized non-standard products which is for flexible production, meeting the heating requirements of various equipment.Fixed threads can be added flexibly.

 

 

When using the threaded cartridge heating element, we should pay attention to the following points:

 

1.When installing the cartridge heater on the container by using internal threaded holes, the internal threaded holes must match the threads of the heating element; otherwise, installation will fail.
 

2. The heating area of the heating tube cannot be separated from the liquid for heating. If so may cause the heating element to be damaged.

 

 

product-1-1

 

 

Data Sheet

Resistance heating wire

NiCr 80/20 wire

Sheath

stainless steel 304,321,316, Incoloy 800, Incoloy 840

Tube diameter

Min is 3mm, max is 30mm

Tube length

min is 15mm max is 3meter.

Wattage Tolerance

+5%, -10%

Resistance tolerance

+10%, -5%

Length tolerance

±1 mm

Diameter tolerance

-0.02mm

Standard Cold Zone

5-10mm

Insulation resistance (cold)

≥ 500 MΩ

Thermocouple Location

type J/K

Maximum leakage current (cold)

≤ 0.5 mA

file0001

file0002.jpg
file0003.jpg

Advantages

1:High-Density Swaged Cartridge Heater

2:Low density cartridge heater are available

3:Various diameter from 3MM-30MM

4:Good Alloy tube sheath for high corrosion resistance

5:Imported resistance wire, ensure high density large wattge

6: Fasteners and flanges to meet a variety of installation requirements.

7:High temperature, wear-resistant, waterproof

Hot Tags: Threaded cartridge heating element, China, suppliers, manufacturers, factory, customized, wholesale, free sample, made in China, DC pencil heating element, Low voltage, Bended Immersion Cartridge Heating Element, 24V DC Thread cartridge heating element, Cartridge Insertion heating element, fast heat cartridge heating element

Send Inquiry

Customer First

We transform your requirements into customer-centric, technologically advanced and economical solutions.