Description

Copper Immersion Heater Element with Thermostat is connected to their own power supply for heating and usually can be easily switched on or off. However, many times the heating process is done automatically via a thermostat. This immersion heater controller will regulate the temperature in the vessel. Immersion heaters can be a backup solution for when the primary heater goes down or a permanent solution and your only source of heat. This heating method is very reliable and has been around for a very long time. So, it has been improved upon and made to be a great way to heat up liquids.

The use of copper immersion heater element with thermostat has been more popular in the past several decades as rising costs of fuels (and the necessary infrastructure that comes with it) force individuals to select a more cost efficient way of heating their applications. Ecologically conscientious groups have long advocated for cleaner energies to help save the environment. Electric immersion heaters have been known to use the cleanest form of energy, leaving no residual discharge and provide immediate heat transfer to any medium.

The flange of the immersion heater is brass,the size can be from 1 1/4"-2 1/4",ITek Brazing, the best performance patented solution for all materials.Thermowatt thermostat including unipolar or bipolar safety circuit breakers.Customizable materials (e.g., copper, stainless steel, high quality nickel alloys, titanium).It can be customized according to customer requirements,protection levels up to IP65 based on demand.

Determining the right heater sheath material for a given liquid isn't difficult, but it does take a little research. Most heater manufacturers give sheath selection tables. Most everyone agrees that, among the lower cost sheath materials, Incoloy gives the longest service life in water heating applications. But, after that, you'll find some manufacturers who rate copper as a "Best" material while others rate it only as a "Good" material. Who are you going to believe!

Rod thermostat is used to keep the water and liquid in the main temerature scope with the immesion heater.

Rod thermostats are available in two main types: Control only, and Combination Control & Cut-Out,

Both are used in domestic immersion heaters, and are made in three stem lengths (measured underneath the head) of 7" (178mm), 11" (279mm), and 18" (457mm). Both have 7.5mmØ stems, designed to fit into a 5/16" (7.9mm) i.d tube. The control thermostats are factory pre-set at 60°C and should be used in conjunction with a separate over-temperature device in domestic applications.

product-825-293

Sometimes,we will find that the water heater works slowly and it is to say that the heating efficiency is not so good.

What's the causes lead to this problem?

1.Maybe the water scale of the copper immersion heater element is too much and the inner heat dissipation can not go out smoothly.

So we must clean the tank and use the Mg anodies.

2.The thermostat problem,if the thermostat do not work well,the water heater can not achieve the setting temperature and stop heating.

Or it will heat slowly or continuous over heating.We must inspect it or replace it.

3.Problem of the immersion heater element,one water tank contain not one set heating element,but 2-3 set,different set has different length in different layer,they have different power.Problem element should be replaced.

Data

No.	Main Parameter
1	Model No.	WNA-8
2	Voltage	220V
3	Material	Copper
4	Power	2000W
5	Length	300mm
6	Flange	1 1/4" barss flange
7	Diameter	48mm
8	Type	With single safety thermostat
9	Certificate	CE.IEC60730